8.10.9 Enrollment Commands
There are three commands available from the Enrollment command menu.
• Add Employee
• Add Supervisor
• Remove User
Refer to Table 10 on page 48 and identify the command you need to perform. Step
through all previous commands until you reach the desired command.
CLEAR
Table 9: Beeper and LED Status During Verification
Operation Beeps LED Meaning
During Keypad
Entry
1 per Keystroke – Keystroke
Accepted
After ID Entry – – OK - Proceed
After ID Entry 2 – ID Number Not in
Database
After Hand
Placement
1 Green ID Verified
After Hand
Placement
2 Red ID Not Verified -
Try Again
After Hand
Placement
1 Long Red ID Refused
HandPunch 1000 Installation and Operation Manual
Page 48 Revision 1.2
8.10.9.1 Add Employee
The Add Employee command allows you to enroll a new employee into the
HandPunch.
8.10.9.2 Add Supervisor
The Add Supervisor command allows you to enroll a new supervisor into the
HandPunch.
8.10.9.3 Remove User
The Remove User command allows you to remove an employee or supervisor from
the HandPunch.